Ashcroft ATE-2 - Handheld Calibrator Manual de usuario descargar pdf (Pagina 42)

When desired FS input value is displayed on screen for example

00110.00000

Press ENTER to accept

HHC will go back to Percent Error MENU and advance to the next

programmable parameter.

Use DOWN or UP ARROW to highlight “Output channel…”

Press ENTER

Use DOWN or UP ARROW to highlight “CH1” (Channel 1

Module) or “CH2” (Channel 2 module) or “External Input…”

Note: Typically external input is used with transducers that pro-

vide voltage or current output signals.

Press ENTER

HHC will go back to Percent Error MENU and advance to the next

programmable parameter..

Use DOWN or UP ARROW to highlight “Output range…”

Note: Typically this is the output range of the device under test.

For this example the unit under test has 0-6Vdc output.

Use DOWN or UP ARROW to highlight “4-20”, “0-X”, “1-X” or

“Custom”

If a range ending in “–X” or “Custom” is selected the operator can

program the numeric value for the variable as follows

Use DOWN or UP ARROW to highlight “0-X”

Output “0-X” screen will be displayed.

Use DOWN or UP ARROW to highlight “0-5” through “0-100”, if

desired value is not displayed select “Custom”

If a custom range is needed:

Select “Custom”

Press ENTER

Display shows “Input FS screen”

SECTION 15 h. PERCENT (%) ERROR FUNCTION

CONT.

Outp ut

Rang e

4-20

0-x

1-x

Custom

Outp ut

0-x

0-5

0-10

0-60

0-100

Custom

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 85 86

Comentarios a estos manuales

Sin comentarios

Ashcroft ATE-2 - Handheld Calibrator Manual de usuario Pagina 42

Comentarios a estos manuales