Ashcroft ATE-2 - Handheld Calibrator Manual de usuario descargar pdf (Pagina 54)

SECTION 15 l. FIRMWARE UPDATE CONT.

Click [Connect].

Both the “Com port status” and the “Device Status” should

indicate “Connected”.

NOTE: If the “Com Port Status” is “Connected” and the “Device

Status” is “Disconnected” you most likely have the wrong COM

port or the device is not in the “Firmware Update” mode. If unsure

of the correct COM port number disconnect the USB cable from

the PC then reconnect to have the PC display a message stating

the new COM port number.

Select the desired Firmware Image File with the sufﬁx “.cyacd” by

clicking the [Browse] button and locating the ﬁle.

Click [Update] to begin transfer



1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 85 86

Sin comentarios

Ashcroft ATE-2 - Handheld Calibrator Manual de usuario Pagina 54